LIGHTING 57

This page is part of my Custom Lighting Mod series of articles.


DISCLAIMER: If you choose to attempt any of these modifications, you assume all risks thereof. I just wanted to share my experiences here. Neither Agora Models, nor myself, are responsible for any damages that may occur.

Lighting Stage 57

Adding an LED to the Rear Wheel Arch Emergency Light

The steps to add this LED, remove the locating pin, and routing the wiring are the same as the ones in the previous Lighting Stage 54 page:

Mounting the Wheel Arch Cover

We are going to use the same hole we drilled back in Lighting Stage 54 for the wiring from this side of the truck as well:

Then, when it was time to mount the Wheel Arch Cover, I fed the new LED plug/wiring through the existing center hole of the Storage Compartment Frame:

Wiring

As with the left side, this LED was connected to the extra Micro Expansion Boards using the Slow Rate Multi-Effects Board:

Next Custom Lighting Page


These Wheel Arch Cover lights represent the last of the custom lighting I added to my FDNY Tower Ladder 9 fire truck. Once they were connected, I tested everything and was able to finally screw the Box Frame Roof Section down. One more stage to go!

LIGHTING 59 – Connecting the IR Receiver and USB Power Cable

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.