LIGHTING 38

This page is part of my Custom Lighting Mod series of articles.


DISCLAIMER: If you choose to attempt any of these modifications, you assume all risks thereof. I just wanted to share my experiences here. Neither Agora Models, nor myself, are responsible for any damages that may occur.

Lighting Stage 38

As in previous stages, I needed to drill a 2mm hole through the center of the Emergency Light Frame in Stage 38. I also created the shallow 2mm recess in the back of the Emergency Light Lens (make sure not to go all the way through the lens):

And, as before, I secured a Micro Bit Light (Red) LED to the back of the Lens with a tiny drop of Solarez UV Thin-Hard Resin:

The plug of the LED was fed through the hole in the Frame and the Lens was secured into place:

I drilled a matching 2mm hole through the center of the rectangular recess in the Step Backplate:

Next, I temporarily fitted this Step Backplate to the Box Frame assembly. I used a sharp pin to mark the location of the hole I just drilled onto the side of the Box Frame:

Then, I drilled a 2mm hole through the Box Frame assembly. This will allow the LED wiring to pass into the Box Frame:

I repeated this process on the other side of the Box Frame, hoping the hole is needed in the same place:

Finally, I threaded the plug of the new Micro LED through the Step Backplate and secured the Emergency Light Frame into place:

This Step Backplate (and the entire Step assembly) will be mounted to the Box Frame in Stage 39. We will attach the wiring then.

Next Custom Lighting Page


LIGHTING 39 – Adding our custom lighting to Stage 39

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.