STAGE 61

 Return to the BUILD


“The same steps are repeated for adding components to the righthand boom section.”

 

Contents


Parts

Materials: While most of these parts are plastic, the Name Plate is metal.

NOTE: Save any spare screws left over at the end of each stage of this build. They may be needed in later stages!

Build


Components for the Right-hand Bed Section

Step 1

Retrieve your right-hand Ladder Name Plate from the previous issue. Fit this Plate to the side of the Right-hand Bed Section, align the screw holes, and secure the Plate to the Bed Section with four (4) Type C screws as shown:

Step 2

Apply a bit of super glue to the back of the Aerialscope 75 Name Plate and fit it into this matching recess of the Right-hand Bed Section:

Step 3

Glue the Spotlight Lens into the Spotlight, as shown.

You may want to use a PVA-based (white) glue here. Super glue (CA glue) has a tendency to fog up clear plastic:

Fit the D-shaped pin of the Spotlight into the matching hole at this location on the Right-hand Bed Section:

Thoughts


We did all of this before in the previous stage, so nothing new here.

Next Up


 Stage 62 – Boom Cogs, Piston Brackets, Pipes, Ladder Bracket

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.