Return to the BUILD

“Next, the heavy body midsection base is installed.




Materials: The Body Midsection Base is metal, while the Cab Button-Push Tool is mostly plastic with a metal base.

NOTE: Save any spare screws left over at the end of each stage of this build. They may be needed in later stages!


Body Midsection Base

Attach the Body Midsection Base

Retrieve your Body Midsection assembly from the previous stage and turn it upside down. Lower the Body Midsection Base into the Body Midsection, as shown:

Secure the Body Midsection Base to the Body Midsection with three (3) Type I screws:

That step completes this stage. As for the Cab Button-Push Tool, it will be used to operate the Push Buttons inside the cab once the model is complete. The angled end is for the buttons on the Dashboard and the flat metal disc on the other end is for pushing the button on the Steering Column. Keep this tool stored somewhere safe until then:


The Midsection Base is a big chunk of metal and is quite heavy. As it sits right under the ladder turntable pivot point, I believe it is meant to keep the truck upright when the ladder is extended up and off to the side. Keep this tool stored somewhere safe until then.

Next Up

 Stage 30 – Box Frame, Rear Body Section Front Panel, Fluid Tank/Cap, Canister Detail, Rope

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.